Hi, I'm Don Raflik with Rockwell Automation.
I'm demonstrating our brand new IEC
MCC, FLEXLINE line motor control center.
I'm going to show you a brief demonstration of our Multi
Drawer and the test positions.
This is a Multi Drawer.
You can see there are multiple units, very flexible in their
design.
You have 1 by 1 modules, 1 1/2 by 1 modules, you have and 3
by 2 modules.
There are lots of different combinations that you can fit in the MCC.
These are called Multi Drawer and a Multi Drawer has different
test positions.
So if you come here with a breaker off, push the red button
in and pull out slightly, and then you'll be in test position.
In test position you'll have power disconnected and motor
leads disconnected from power. But control power is still
present.
Push again, move out to disconnect mode.
In disconnect mode, both control power and power and motor leads
are disconnected.
Push the button in one more time and remove, and it's
completely disconnected.
You can remove the drawer completely and be able to do
maintenance on that unit.
For the opposite, you just slide it back in. Push the button, you
can slide it back in as well. If you want to do Lockout/Tagout
in a specific position, like disconnected mode or test mode,
rotate the red handle. And now it will not go in or out and you
cannot press the button.
You can place a lock, a 6 millimeter shank lock in here and lock it
out.
Also you can lock out the breaker, if necessary, for
Lockout/Tagout procedures. To reinsert, rotate the handle 90 degrees,
push in the button and insert.
And that's our Multi Drawer test position demonstration.